Idiomas disponibles
Idiomas disponibles
□
Insert a wall plug
14
□
Unscrew the mounting plate peg anticlockwise
from the wall mount peg
□
Loosen the hex socket grub screw in the wall
mount peg by using the hex key
anti-clockwise a few times, and remove the wall
mount peg from the shower rod.
□
To attach the mounting plate to the wall, insert
a screw
through each hole in the mounting
13
plate and screw them into the drill holes using a
Phillips-head screwdriver.
□
Slide the cover
over the mounting plate peg
4
so that the cover is flush with the wall.
□
Screw the wall mount peg onto the mounting
plate peg until hand-tight.
□
Place the shower rod back onto the (up-
ward-facing) shower rod connector and screw
the union nut onto the thread until hand-tight.
□
Insert the shower rod holding pin
corresponding opening in the wall mount peg.
□
To attach the shower rod to the wall mount,
tighten the hex socket grub screw by turning it
clockwise with the hex key.
•
Installing the handheld shower
□
Insert a sealing ring
tor on the shower hose
□
Screw this connector to your hand-held shower
head
until hand-tight.
6
□
Insert a sealing ring into the ribbed connector
on the shower hose.
□
Screw the free connector on the shower hose
to the (downward-facing) shower hose connec-
tor
.
16
□
Slide the handle of the handheld shower head
through the opening of the handheld shower
head bracket
to hang it there.
23
•
First use
□
Once successfully installed, turn on the hot and
cold water supply.
□
Make sure to carefully check that all connec-
tions are leak-tight after the first use.
into each drill hole.
.
3
to turn it
17
into the
2
into the smooth connec-
7
.
8
•
Operation
•
Regulating the temperature
Note: The temperature control stops at around
38 °C. Press the release button on the temper-
ature control
to set a higher temperature if
15
necessary.
□
Set the desired water temperature using the
temperature control.
Turning it clockwise reduces the water temper-
ature and turning it anti-clockwise increases the
water temperature.
•
Regulating the water flow
□
Turn the flow control clockwise to regulate the
water flow for the handheld shower head.
□
Hold down the release button on the flow
control and turn the control anti-clockwise to
regulate the water flow for the overhead shower
head.
□
Turn the flow control to the central position to
turn off the water flow.
•
Adjusting the handheld shower
head bracket
□
Loosen the clamping mechanism
it anti-clockwise a few times.
□
Slide the handheld shower head bracket
the desired height.
□
To fix the handheld shower head bracket at the
desired height, tighten the clamping mechanism
by turning it clockwise.
•
Adjusting the overhead shower
head
□
Loosen the upper part of the shower rod
turning the lever on the shower rod bracket
anti-clockwise a few times.
□
Adjust the overhead shower head
desired height by pulling the upper part out
of the shower rod or pushing it down into the
shower rod.
□
To fix the shower rod at the desired height,
tighten the lever on the shower rod bracket by
turning it clockwise.
First use
by turning
22
to
23
by
24
1
to the
25
GB/IE
17
