Dräger Junction Box Ex d Instrucciones De Montaje página 12

en | Safety instructions
1 Safety instructions
Junction Box Ex d
Before using the product, carefully read the instructions for use of the gas
detector used. This document does not replace the instructions for use.
2 Description
2.1 Product overview
X
1
2x
2x
12x
2
12
Y
2x
4
3
X
Remote cable harness set for Polytron
Y Remote cable harness set preassembled in sensor connection housing
1
Screws for mounting the remote cable harness in Polytron
2
Screw bridges for mounting in the remote cable harness set Polytron
5000/8000 (for 3-core field wiring)
3 Screw bridges for mounting in the remote cable harness set Y (for 3-core
field wiring)
4 Ferrules for field wiring
1) not relevant for PointGard
2.2 Intended use
The Junction Box Ex d is an explosion-proof sensor connection housing that
makes it possible to install the sensor separately from the transmitter. The
sensor connection housing can be connected to a controller via a
Polytron 5000/8000 or PointGard 3200/37x0. If the sensor connection housing
is operated with a PIR 7x00, it can also be connected directly to a controller.
The sensor connection housing can be used to measure gases in ambient air or
in a duct/pipe. It is suitable for wall, ceiling and duct mounting.
The housing consists of robust stainless steel or aluminum and is suitable for
indoor or outdoor applications.
Assembly instructions
® 1)
5000/8000
®
5000/8000
®
1)
|
Junction Box Ex d
1)