Idiomas disponibles
Idiomas disponibles
Optional Installation
1
USB and RS-232 Serial
Communications
Use the included USB cable
1b
serial cable
communication port on your computer to the
communication port of your UPS. Install on
your computer the Tripp Lite PowerAlert
Software appropriate to your computer's
operating system. Consult your PowerAlert
manual for more information.
2
Telephone/Network Protection Jacks
Your UPS has jacks that protect against surges
over a telephone line or a network dataline.
Using telephone network data cables, connect
your wall jack to the UPS jack marked "IN."
Connect your equipment to the UPS jack
marked "OUT." Make sure the equipment you
connect to the UPS's jacks is also protected
against surges on the AC line.
Not compatible with PoE (Power Over Ethernet)
applications.
Basic Operation
16-02-272-932442.indb 4
1a
and/or DB9
to connect the
Buttons
"STANDBY" Button
• To turn the UPS ON: with the UPS plugged into a live AC wall
outlet,* press and hold the STANDBY button for about one
second.** Release the button. If utility power is absent, you can
"cold-start" the UPS (i.e.: turn it ON and supply power for a limited
time from its batteries***) by pressing and holding the STANDBY
button for about two seconds.**
• To turn the UPS OFF: with the UPS ON and receiving utility power,
press and hold the STANDBY button for one second.** Then unplug
the UPS from the wall outlet. The UPS will be completely OFF.
* After you plug the UPS into a live AC outlet, the UPS will automatically charge its
batteries, but will not supply power to its outlets until it is turned ON. ** The
alarm will beep once briefly after the indicated interval has passed. *** If fully
charged.
1a
1b
2
4
2/18/2016 4:55:12 PM
