Tabla de contenido
EN Dometic TD283
NOTICE! Damage hazard
• Ensure that other objects cannot cause a short circuit at the contacts of the device.
• Do not use the device in wet conditions or submerge in any liquid. Store in a dry place.
Installing the device safely
CAUTION! Electrocution hazard
• Installation and removal of the device may only be carried out by qualified personnel.
• Crushed cables can lead to moderate injury.
CAUTION! Risk of injury
When positioning the device, ensure that all cables are suitably secured to avoid any form of trip hazard.
NOTICE! Damage hazard
• Do not place the device near heat sources (heaters, direct sunlight, gas ovens, etc.).
• Set up the device in a dry location where it is protected against splashing water.
• Before start-up, check that the voltage specification on the data plate is the same as that of the pow-
er supply.
NOTE Use N-BUS connection cables when connecting N-BUS-capable devices.
4
Lay the cables so that they cannot be damaged by the doors or the hood.
Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other panels
with sharp edges.
Do not lay cables so that they are loose or heavily kinked.
Do not pull on the cables.
Tabla de contenido
