Tabla de contenido
6. Select the checkbox next to
7.
Select the checkbox next to
AGM2 batteries only: Desulfation phase (Desulf) is activated when the corresponding charging program is se-
lected.
8. Enter the value (in A) for the maximum charging current of all connected chargers.
Making basic settings for the solar charge controller
For the display to function correctly, the nominal output (in Wp) for the connected solar panels must be set.
NOTE The setting is only available if an N-BUS-capable solar charge controller is connected in the N-BUS
network.
1.
Select
to open the settings menu.
Solar Panel
2. Go to
3. Enter the nominal output (in Wp) for up to 2 solar panels (PS1 and PS2).
10 Cleaning and maintenance
NOTICE! Damage hazard
• Do not use abrasive cleaning agents or hard objects during cleaning as these may damage the de-
vice.
• Do not use cleaning agents that contain ammonia or alcohol.
• Never spray or pour liquid directly onto the touchscreen or casing.
Clean the touchscreen with a clean and dry microfiber cloth in small circular motions. Slightly moisten the mi-
crofiber cloth if necessary.
Occasionally clean the casing with a damp cloth.
11 Troubleshooting
Problem
The display does not work. No values
are measured.
Float
to activate the trickle charging phase (Float).
Recondition
to activate the reconditioning phase.
.
Possible cause
The communication cable is not con-
nected correctly or defective.
Insulation faults, breaks or loose con-
nections at the live cables of the con-
nected N-BUS devices.
The house battery voltage is too low
(≤ 7 V).
Dometic TD283 EN
Suggested remedy
Check the connection cable for
loose connections or insulation
faults and breaks.
Replace the communication ca-
ble if necessary.
Check the live cables for insula-
tion faults, breaks or loose con-
nections.
Check the house battery volt-
age. Recharge the house battery
if necessary.
23
Tabla de contenido
