Tabla de contenido
As soon as the Bluetooth function is activated, the
Opening an overview of connected N-BUS devices
1.
Select
to open the settings menu.
BUS
2. Go to
.
A list of the connected N-BUS devices is displayed. The master interface is highlighted in blue.
Making settings
Setting a standby time
NOTE By default, the display automatically switches to standby mode after 3 min without operation.
1.
Select
to open the settings menu.
Display
2. Go to
.
3. Set a value between 1 and 100 for the time (in minutes) after which the backlight is to be dimmed (2).
With the backlight dimmed, the power consumption of the display is reduced to half of the power consumption
at full brightness (see chapter
4. Set a value between 1 and 100 for the time (in minutes) after which the display switches to standby automatically
(1).
In standby mode, the display backlight is completely switched off, the power consumption of the display is re-
duced to 15 mA (see chapter
symbol in the status bar lights up yellow.
Technical data
on page 24).
Technical data
on page 24).
Dometic TD283 EN
19
Tabla de contenido
