Tabla de contenido
EN Dometic TD283
1.
Detach the mounting plate from the display cover.
2. Place the mounting plate on the mounting surface and mark the mounting holes and the communication cable
connection.
3. Drill mounting holes for the mounting plate (Ø 3 mm) and an opening for the communication cable connection
(Ø 8 mm) at the marked points.
4. Route the communication cable through the communication cable connection and the prepared hole in the
mounting surface.
5. Screw the mounting plate to the mounting surface.
Connecting the display
1.
Connect the communication cable to the display.
2. Attach the display cover to the mounting plate.
Connecting N-BUS devices
NOTE Use N-BUS connection cables (accessories) when connecting N-BUS-capable devices.
16
Tabla de contenido
