Etac Alto Manual Del Usuario página 23

Ocultar thumbs Ver también para Alto:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
Troubleshooting guide
Problem
LED-light F9 flashes.
Raising, lowering or tilting does not
work.
The battery is not charging.
The seat tilts sideways.
The hand control does not start. There
is a beeping sound when the "Stand by"
button is pressed.
Accessories
1.
Leg and calf support, elevating
2.
Foot plate, leg and calf support
3.
Angle adj. foot support
4.
Amputee leg support
5.
Commode pan
6.
Pan-holder attachments
Attachments for low pan-holder
7.
mounting
8.
Commode pan holders
9.
Bucket holders
10. Pan
11. Lid with handle
12. Splash guard
Soft Comfort seat, 2 cm high, open
13.
at back
Soft Comfort seat, 4 cm high, open
14.
at back
Possible cause
The battery is almost discharged.
The hand control has been deactivated.
The mains cable is plugged in for charg-
ing.
Cables are incorrectly connected.
The battery is discharged.
Battery failure.
Actuators at different heights.
The battery has been stored at a tem-
perature outside the specified storage
temperature.
15. Comfort seat
16. Soft Comfort seat
17. Soft Comfort seat - narrow opening
18. Soft cushion - standard opening
19. Soft cushion - oval opening
20. Seat cover
21. Soft back pad
22. Comfort padding
23. Arm support cushion, pair
24. Trunk support
25. Chest and hip positioning belts*
26. Chest belt
27. Hip belt
28. Crossbar 605 mm
23
Etac / Alto / www.etac.com
Action
Charge the battery.
Switch the hand control back on by
pressing and holding the "Stand by"
button for 3 seconds.
Unplug the mains cable and switch the
hand control back on by pressing the
'Stand by' button for 3 seconds.
Have the product serviced
Charge the battery.
Have the product serviced
Perform a reset by pressing the "down"
and "up" buttons simultaneously for 5
seconds. The frequency of the signal
will increase after 5 sec., then hold the
"down" button until the seat is in the
lowest position. When the button "down"
is released the signal will stop.
Plug the mains cable into the mains
socket. Unplug the mains cable and
turn on the hand control by pressing the
"Stand by" button for 3 seconds.
See Figure G
29. Head support and bracket
30. Heel straps
31. Hemiplegic arm support
32. Arm support lock
33. Short leg support
34. Angled leg support
35. Widening kit for leg support
36. Wipeable back support
37. Head support upright
38. Seat closed at the back
39. Pan holder
40. Bucket with handle and lid
41. Cover leg- and calf support
42. Castor direction lock
*With wipeble back only as hip belt
loading

Este manual también es adecuado para:

80229600802296058022960980229608