Makita JR001GZ Manual De Instrucciones página 8

Lighting up the front lamp
► Fig.5: 1. Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after
releasing the switch trigger.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: When the tool is overheated, the lamp blinks
for one minute. In this case, cool down the tool before
another operation.
Adjusting the shoe
When the recipro saw blade loses its cutting efficiency
in one place along its cutting edge, reposition the shoe
to utilize a sharp, unused portion of its cutting edge.
This will help to lengthen the life of the recipro saw
blade.
The position of the shoe can be adjusted in 6 levels.
To reposition the shoe, open the shoe adjusting lever
and select the suitable position, then close the shoe
adjusting lever.
► Fig.6: 1. Shoe 2. Shoe adjusting lever
NOTICE:
The shoe cannot be secured if
it is extended more than the
of stamping. Do not close the shoe
adjusting lever forcibly in such a position. It may
result in breakage of the lever.
NOTE: The shoe cannot be adjusted without opening
the shoe adjusting lever fully.
Hook
CAUTION:
When hanging the tool, set the
lock/speed change lever in
the switch trigger. (See the section titled "Switch
action" .)
CAUTION:
Never hang the tool at high or
potentially unstable location.
► Fig.7: 1. Hook
The hook is convenient for hanging the tool temporarily.
To use the hook, simply lift up hook until it snaps into
the open position.
When not in use, always lower hook until it snaps into
the closed position.
marking
position to lock
8 ENGLISH
Electronic function
The tool is equipped with the electronic functions for
easy operation.
Constant speed control
The speed control function provides the constant rota-
tion speed regardless of load conditions.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing the recipro
saw blade
CAUTION:
Always clean out all chips or for-
eign matter adhering to the blade and around the
blade clamp. Failure to do so may cause insufficient
tightening of the blade, resulting in a serious injury.
To install the recipro saw blade, pull the release lever
fully so that the blade clamp sleeve comes to the
released position before inserting the recipro saw blade.
► Fig.8: 1. Release lever 2. Blade clamp sleeve
3. Released position 4. Fixed position
NOTE: Always pull the release lever fully to the end.
If not, the blade clamp sleeve does not come to the
released position and the recipro saw blade cannot
be inserted.
Insert the recipro saw blade into the slot of the blade
clamp sleeve as far as it will go. The blade clamp sleeve
will catch the recipro saw blade with a click. Make sure
that the recipro saw blade cannot be extracted even
though you try to pull it out.
► Fig.9: 1. Recipro saw blade 2. Blade clamp sleeve
CAUTION:
If you do not insert the recipro saw
blade deep enough, the recipro saw blade may be
ejected unexpectedly during operation. This can
be extremely dangerous.
To remove the recipro saw blade, pull the release lever
in the direction of the arrow fully.
► Fig.10: 1. Recipro saw blade 2. Release lever
NOTICE:
Never operate the release lever when
operating the switch trigger. Doing so may cause
malfunction.