Idiomas disponibles
Idiomas disponibles
ANTI-TIP BRACKET INSTALLATION
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
NOTE: The installation of the ANTI-TIP bracket must meet all
local codes for securing the appliance.
If you did not receive an anti-tip bracket with your purchase,
For installation instructions of the bracket, visit:
GEAppliances.com. In Canada, GEAppliances.ca.
1. LOCATE THE BRACKET
IMPORTANT: Determine the final location of the
range before attempting to install the bracket.
edge against the rear wall. If the range does
not reach the rear wall, align the back edge of
the bracket with the rear panel of the range in
its final location.
the left or right cabinet. If there is no adjacent
cabinet, align the edge of the bracket with the
side panel of the range in its final location. If
the countertop overhangs the cabinet, offset
the bracket from the cabinet by the amount of
overhang.
Adjacent cabinet
or final location of
range side panel
Location A
Installation Instructions
WARNING
Tip-Over Hazard
Rear
Wall
Location B
2. SECURE THE BRACKET
The bracket must be screwed to the floor. Two
screws on each side of Location A or B must be
used to secure bracket to floor.
Screw must enter
the subfloor
thread engagement with the subfloor, making
sure to check bracket engagement after
installation.
3. CHECK THE BRACKET
After installing the bracket, slide the range into its
final location. The rear leveling leg must be fully
inserted into the ANTI-TIP bracket as shown in
engaged properly, look underneath the range to
see that the rear leveling leg is engaged in the
bracket. The storage drawer can be removed for
easier inspection. After visual inspection, verify
the rear leveling leg is properly secured within
the bracket by carefully tipping the range forward.
DO NOT tip the range more than 4 inches. If the
bracket does not stop the range within 4 inches,
be reinstalled following these instructions.
WARNING
he anti-tip bracket must be
T
remove the leveling legs. Removal of the leveling
legs will prevent the range from being secured to
the ANTI-TIP bracket properly.
Bracket
49-2001048 Rev. 5
