NSK VarioSurg Manual Del Operador página 15

7. Operation
7-1 Mounting and Removing the Tip
1) First, lightly screw in the Tip with your hands (Fig. 19).
2) Matching the square shapes of the Tip and the hole of the Tip Wrench, insert the Tip into the hole (Fig. 20).
3) Rotate the wrench in the tightening direction, as shown in Fig. 21 and 22, until it makes a clicking sound as it
spins without tightening any further.
To remove the Tip, rotate the wrench in the loosening direction shown in Fig. 21 and 22.
Loosen
CAUTION
• Be careful when mounting or removing a Tip that is longer than the Tip Wrench, as the end of the Tip that sticks
out of the wrench might cause injury.
• Rotating the wrench at an angle may damage the thread or the Tip so that it cannot be tightened enough to
produce vibrations.
• Always mount a sterilized Tip.
• Do not use damaged, bent, or rusty Tips as they might break during use.
• Tips wear down and decrease in cutting power. Change the Tip when its cutting power has decreased.
• Tip Wrench is consumable. For reliable operation replace annually.
Fig.19
Tighten
Fig.21
14
Fig.20
Fig.22