ADURO P5 Lux Manual De Usuario página 47

If you experience problems with getting the stove online, it may be due to your local Wi-Fi network, your
router, or the telephone setup. It is not Aduro's responsibility to ensure connection. Some of our dealers offer
the service to connect the stove to Wi-Fi.
5.7 Aduro Pellet Stove App
When you have set up the stove with the Aduro Pellet Stove app, you can start the stove (press the gear
icon) and choose "run by heat level" "room temperature" or "calendar". Setting up the calendar is performed
on the remote.
5.8 Initial pellet load
After filling the pellet container with pellets for the first time, the auger needs to be filled with pellets. Move
the brazier so you can see the top of the internal auger. Close the door so the door sensor is activated and
use the menu INITIAL LOAD on the remote, and press "+" to start the augers for 6 minutes. Push STOP
INITIAL LOAD when the first pellets are visible at the top of the auger. The first time it may be necessary to
run INITIAL LOAD a couple of times (10-12 minutes).
Whenever the pellet container runs empty during operation, ALARM 6 will appear on the display (see also
Potential Errors) and it may be necessary to run INITIAL LOAD again.
5.9 Turning the stove on and off
Accumulated and unburned pellets in the brazier must be removed before lighting the stove. Check that the
brazier is clean and positioned properly before lighting.
Start the stove via the app or by pressing the "ON/OFF" button on the remote or on the control panel.
As soon as the exhaust gases have reached a temperature of 80°C, the current status will switch to WORK.
Turn off the stove via the app or press and hold the "ON/OFF" button until the status switches to FINAL
CLEANING on the remote or the control panel.
47