Idiomas disponibles
Idiomas disponibles
NOTICE
If the issue persists after troubleshooting and fol-
lowing the instructions offered in the app, then
please contact Ford Customer Service.
NOTICE
In case there is no Fordpass app Message, unplug
the vehicle coupler, cycle the circuit breaker off
and back on. The Ford Connected Charge Station
will indicate Power on Status (blue center LED)
within two minutes. After this you can plug the
coupler and proceed with normal operation
If after three attempts the error persists, unplug
the vehicle coupler and report to Ford there is a
vehicle problem.
6
Commissioning the product
6.1
Preparing to setup the product
Steps to prepare for commissioning the charge station:
1.
Download the FordPass™ app, this will be used to
connect your Ford Connected Charge Station to your
FordPass account.
2.
Download the Ford Connected Charge Station Setup
app, this will be used to configure the charge station
to your home Wi-Fi.
3.
Locate the Station ID and Access Code on the front of
your charge station or on the front page of the Opera-
tion Manual .
4.
Make sure that you have a Wi-Fi signal (for the net-
work that you want to run the charge station on) at
the charge station location.
6.2
Setting up the product
1.
Stand near your charge station and turn on Bluetooth
on your smartphone.
2.
Start the FordPass™ app.
3.
Select More from the FordPass™ navigation bar.
4.
Select Your charge station.
5.
Follow the in-app instructions to complete the setup:
– Select your Station ID from listed charge stations.
10
– Enter your Access Code.
– Locate, and connect to your Wi-Fi network.
6.3
Displaying software license
information
You can view the open-source software license information
under the About option in the Ford Connected Charge Sta-
tion setup App. You must be logged into the same Wi-Fi net-
work as the Ford Connected Charge Station. Both devices
must connected.
7
Decommissioning the product
The Ford Connected Charge Station must be decommis-
sioned by a qualified electrician.
The following steps apply:
1.
Switch off the charge station circuit breaker.
2.
Electrically disconnect the charge station and ensure
that open and hot connections are not accessible.
3.
Dispose of the Ford Connected Charge Station in ac-
cordance with local and national rules and regula-
tions.
8
Maintenance, cleaning, and repair
8.1
Maintenance
The Ford Connected Charge Station does not require routine
maintenance other than periodic cleaning as described be-
low
Maintenance should only be carried out by a qualified elec-
trician and must be in accordance with local regulations,
standards, and requirements.
8.2
Cleaning
The Ford Connected Charge Station does not require any
routine maintenance other than periodic cleaning as de-
scribed below.
Use a dry cloth only to clean the Ford Connected Charge Sta-
tion. Never use aggressive cleaning agents, solvents, fuel, or
wax.
LJ98-10C823-AC / LJ98-10C823-AD
DANGER
High voltages.
Danger of fatal electric shock. Never clean the
charge station with a high-pressure cleaner or
similar device.
8.3
Repair
Unauthorized repair of the Ford Connected Charge Station is
not permitted. In the event of a failure, replace the entire
unit. Ford Motor Company Limited (Ford) reserves the exclu-
sive right to perform repairs to the charge station . The only
components that can be serviced are the design cover, the
charging cable and the remote dock. The charging cable
must be installed by a qualified electrician.
NOTICE
The charging cable can be replaced a maximum
of four times over the lifetime of the charge sta-
tion.
9
Declaration of Conformity
Ford Motor Company Limited (Ford) hereby declares that
the radio equipment type "Ford Connected Charge Station"
conforms to ANSI/UL2594:2016 and to CAN/CSA-C22.2 No.
280-16, No 281.1-12 and No. 281.2-12 applied for general use
of power supplies.
The Ford Connected Charge Station also conforms to the
following standards and regulations:
l ANSI/UL2594:2016
l UL2231-1, UL2231-2
l FCC Part 15, Subpart B and C
l NEC Article 625 compliant
The Ford Connected Charge Station was developed, manu-
factured, tested, and supplied in accordance with the
above-mentioned standards and regulations, and in accor-
dance with the relevant standards for safety, electromag-
netic compatibility (EMC), and environmental compatibility.
Ford Connected Charge Station Operation Manual
