Air Filter - TRAPP MC-80G Manual De Instrucciones

Warning!
All maintenance and cleaning should
be made with the equipment
switched off and the spark plug wire
disconnected.
The air filter shall be always clean for the
engine to work perfectly.
Blocking of the filter due to lack of
cleaning causes serious operating
problems for the engine, among them loss
of power, and damage to the cylinder,
piston and piston rings.
4
2
3
36
Fixing the Handle to the Base
7
9
8
5
6
1

Air Filter

Air filter - foam
✔
Dip and tighten (do not twist) it in a
solution of neutral detergent water,
removing all the dirt.
✔
Dry it, rolling and pressing it in a dry
cloth (do not twist it).
✔
Moisten the filter slightly with clean oil
(20W-40), always pressing it to
distribute the oil equally, removing the
excess.
Air filter - paper
✔
Pass compressed air from inside to
outside the filter or knocking its base
lightly against a flat surface.
To fix the handle to the base, proceed as
follows:
Take the lower handle (1) and fit the hole
(2) to the support pin (3). Place the screw
(4), the washer (5) and tighten them with a
butterfly nut (6). After that, take the upper
handle (7) and place the screw (8).
Tighten it with the butterfly nut (9).