Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador página 71

Disabled. The parameter is not displayed.
Enabled.
After a period of time set with parameter
less of the parameter , and then closes the gate.
Enabled.
If the gate is closed as a result of a step mode command, after a period of time set with parameter
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after a period of
time set with parameter .
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes after a period of
time set with parameter .
Setting safeguarded closure/opening activation time
N.B.: this parameter is not visible if the value of parameter
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Selection of the battery operation management
Setting a value different than
via parameter and an error alert can be activated through the COR output via parameter
The control unit always accepts commands until the battery is completely exhausted. When the battery voltage drops to
the minimum allowed, the message
The command becomes active when the battery voltage drops to the minimum threshold (22V
36.4V for battery 3x12V
The command becomes active when the battery voltage drops to the medium threshold (23V
36.8V for battery 3x12V
The command becomes active when the battery voltage drops to the maximum threshold (24V
37.2V for battery 3x12V
Selecting the battery operation limitations
N.B.: the parameter is visible only if par.
There is no limitation for the commands when the battery voltage drops under the selected threshold. An error alert may
be activated via the COR output (if parameters
When the battery voltage drops under the threshold selected with par.
commands and does not perform closing.
When the battery voltage drops under the threshold selected with par.
automatically opens the barrier's boom and accepts only a closing command.
It accepts only closing commands even if the ORO input is active and if the parameter is
When the battery voltage drops to the threshold selected with par.
automatically closes the gate and accepts only one opening command.
Selection of the battery type and consumption reduction
NOTE: An INCORRECT setting of this parameter, when there is no mains voltage, blocks the functions and the display
shows the message (if set to
Battery 24V (2x12V ) with B71/BCHP. Acceleration/deceleration/speed reduction enabled, to increase the battery life.
Battery 36V (3x12V
to increase the battery life.
Battery 36V (3x12V
consumption.
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
P1
P2
x4 s
• The default factory settings have now been restored.
Note:
version appears on the display, press and hold down the
a battery voltage level check is activated. The desired operation type can be selected
appears on the display (20V with B71/BCHP battery charger; 23.7V with B71/
)
)
)
is different than
and are adequately set).
or and the battery is 2x12V
Warning! Restoring default settings cancels all settings made previously
except for parameter
are suitable for the installation.
• Press and hold the PLUS + and MINUS - button until the unit switches on.
• The display flashes after 4 s
), and then the gate closes.
= .
, the control unit accepts only opening
, after a 5 s pre-flashing, the control unit
the control unit, after a prelamping of 5s,
) or an error alert
, , , : after restore, check that all parameters
.
(UP ARROW) and (DOWN ARROW) buttons for 4s.
-
, the control unit
.
for battery 2x12V ;
for battery 2x12V ;
for battery 2x12V ;
.
.
71