Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador página 54

6
Description of connections
To access the control connection terminal board, remove the motor cover as shown in
Figure 2-3-4-5 shows connection diagrams for connecting mains voltage to the motor control unit.
6.1
Typical installation
2
7
1
8
It is the installer's responsibility to verify the adequacy of the cables in relation to the devices used in the
installation and their technical characteristics.
1 Power supply
2 Photocell - Receiver F4ES/F4S
3 Photocell - Transmitter F4ES/F4S
LED Flashing light R92/LED24 - FIFTHY/24
4
Power supply 24V
Antenna
5
Key selector R85/60
Key pad H85/TTD - H85/TDS
(connecting to H85/DEC - H85/DEC2)
6
H85/DEC - H85/DEC2
(connecting to control unit)
Gate open indicator
7
Power supply 24V
Courtesy light (Potential free contact)
8
Power supply 230V~ (100 W max)
SUGGESTIONS: with existing installations, we recommend checking the cross section of the cables and that
the cables themselves are in good condition.
54
5
4
3
3W max
Recommended cable
H07RN-F 3x1,5 mm double insulated cable
2
Cable 4x0,5 mm (max 20 m)
2
Cable 2x0,5 mm (max 20 m)
2
Cable 2x1 mm (max 10 m)
2
Cable 50 Ohm RG58 (max 10 m)
Cable 3x0,5 mm (max 20 m)
2
Cable 2x0,5 mm (max 30 m)
2
Cable 3x0,5 mm (max 20 m)
2
The number of conductors increases when using more
than one output contact on H85/DEC - H85/DEC2
Cable 2x0,5 mm (max 20 m)
2
Cable 2x1 mm (max 20 m)
2
:
6
2
3