Programming And Startup; Controls And Commands - Erreka VIVO-M201 Manual Del Instalador

PROGRAMMING AND STARTUP

1

CONTROLS AND COMMANDS

Close Open
FCA2 COM FCC2 SCA
P1 P2 P3 P4 P5 P6 P15 P14 P16 P7 P8 P11 P12
ST1 FT1 ST2 FT2 FCA1 FCC1 STOP LOCK
Operation Pedestrian
SW2 functions
Functions during programming (DIP1=ON)
DIP2=ON: total open/close programming (see
page 49)
DIP3=ON: pedestrian open/close programming (see
page 50)
DIP4=ON: total opening radio code programming (see
page 48)
DIP6=ON: pedestrian opening radio code
programming (see page 48)
Functions during use (DIP1=OFF)
DIP2: advance warning

DIP2=ON: the flashing light comes on and the
operation begins after a 3 second warning.

DIP2=OFF: the flashing light comes on and the
operation begins immediately.
DIP3: step-by-step or collective opening

DIP3=ON: step-by-step opening (the control
board obeys the key device during opening).

DIP3=OFF: collective opening (the control
board does not obey the key device during
opening).
G4 G5 G6 G1 G2 G3
P22 P23 G7 G8 G9 G10
N L
POWER
Courtesy
24Vac Lamp.
MOTOR2 (G2-G1-COM) MOTOR1 (G2-G1-COM)
Light
P167A
SW1
Main switch
SW2
Programming DIPs
ST1
Total operation mini-pushbutton
ST2
Pedestrian operation mini-pushbutton
PUL1 Close mini-pushbutton
PUL2 Open mini-pushbutton
T.D
Regulation of the lapse between leaves during
closing (max. 20 seconds)
T.LG
Garage light time regulation
T.E.
Standby time regulation (only works in
automatic mode)
P.M.
Torque regulation (maximum thrust)
DIP4: automatic or step-by-step closing mode (in
total and pedestrian operation)

DIP4=ON: Automatic mode (the gate closes
automatically after standby time has passed, which is
adjusted using T.E.).

DIP4=OFF: step-by-step mode (the gate only
closes when receiving the key command).
DIP5: back pulse/close pulse

DIP5=ON: back pulse activated. Should soft stop
be selected (DIP8=ON), a close pulse is also made.

DIP5=OFF: close and back pulse disabled.
DIP6: automatic closing mode optional (with DIP4=ON only)

DIP6=ON: during standby, the gate obeys the
key device (this can be closed before standby time
finishes).

DIP6=OFF: the gate cannot be closed until
standby time finishes.
DIP7: maintain hydraulic pressure (for hydraulic
operators only)

DIP7=ON: maintain hydraulic pressure activated.
A close pulse is sent every half an hour as of the last
operation.

DIP7=OFF: maintain hydraulic pressure disabled.
DIP8: slow down function

DIP8=ON: the leaves reduce their speed before
reaching the stopper.

DIP8=OFF: the leaves reach the stopper at high
speed.
DIP9: without function, place in OFF
DIP10: without function, place in OFF
English
Control board VIVO-M201(M)
47