Idiomas disponibles
Idiomas disponibles
Installation and operation
CAUTION
Do not operate this pump
without personal protective
equipment. Pump can gen-
erate noise levels above 85
dBa that could result in hearing loss.
Failure to comply could result in per-
sonal injury.
WARNING
Do not exceed lowest pressure rating of
any component in system.
Failure to comply may result in
serious injury or death.
WARNING
Do not operate pump with broken,
missing or defective parts. Replace
defective parts prior to operation.
Failure to comply may result in
serious injury or death.
WARNING
Do not operate with leakage in system.
Disconnect air to motor.
Failure to comply may results in
serious injury.
Installation
NOTE
The following procedures consider the
pump to be installed onto a container
with a cover.
1 Install bolts that attach cover to pump.
Tighten bolts securely.
2 Place follower into container.
3 Press downward and maneuver follower
until grease appears around its edges
and center hole. Make sure all air is
removed.
4 Install pump through follower and onto
container.
5 Secure cover and pump to container.
Additional items that should be incorpo-
rated into air piping systems are listed in
Table 5, page 14.
Air line components
Item
Description
338862
Moisture separator/regulator and gauge combination
5608-3
Moisture separator
7608-B
Regulator and gauge
5908-3
Lubricator
1)
Although the air motor is lubricated at the factory, the life of the motor can be extended with the use of a lubricator.
Alternative accessory items
Application
Followers
Single-post hoist
327242
Dual-post hoist
327690
14
Alternate
installations
Pump model 7785-A5 can be mounted from
a single-post hoist, dual-post hoist, or in
bulk grease distribution systems.
When either of these type arrangements
are employed, alternate accessory items
must be purchased (→ Table 6, page 14).
1)
Table 6
Adapter kit
327247
327247
Table 5
