DeWalt DCD980 Manual De Instrucciones página 37

Fig. F
5
6
7
HAMMERDRILLING
Torque Adjustment Collar (Fig. D–F)
Your tool has an adjustable torque screwdriver mechanism
for driving and removing a wide array of fastener shapes
and sizes. Circling the torque adjustment collar
numbers. These numbers are used to set the clutch to
deliver a torque range. The higher the number on the collar,
the higher the torque and the larger the fastener which can
be driven. To select any of the numbers, rotate until the
desired number aligns with the arrow.
Three-Speed Gearing (Fig. D–F)
The three-speed feature of your tool allows you to shift
gears for greater versatility. To select speed 1 (highest
torque setting), turn the tool off and permit it to stop. Slide
the gear shifter 7 all the way forward. Speed 2 (middle
torque and speed setting) is in the middle position. Speed 3
(highest speed setting) is to the rear.
NoTE: Do not change gears when the tool is running.
Always allow the drill to come to a complete stop before
changing gears. If you have trouble changing gears, make
sure that the gear shifter is engaged in one of the three
speed settings.
Keyless Single Sleeve Chuck (Fig. G–I)

WARNING: Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part of the
chuck and turning the tool on. Damage to the chuck
and personal injury may result. Always lock off trigger
switch and disconnect tool from power source when
changing acces sories.

WARNING: Always ensure the bit is secure before
starting the tool. A loose bit may eject from tool
causing possible personal injury.
Your tool features a keyless chuck
sleeve for one-handed operation of the chuck. To insert a
drill bit or other accessory, follow these steps.
1. Turn tool off and disconnect tool from power source.
2. Grasp the black sleeve of the chuck with one hand
and use the other hand to secure the tool as shown
in Figure F. Rotate the sleeve counterclockwise (as
viewed from the front) far enough to accept the desired
accessory.
5 are
with one rotating
4
3. Insert the accessory about 3/4" (19 mm) into the chuck
and tighten securely by rotating the chuck sleeve
clockwise with one hand while holding the tool with the
other hand. Continue to rotate the chuck sleeve until
several ratchet clicks are heard to ensure full gripping
power.
Be sure to tighten chuck with one hand on the chuck sleeve
and one hand holding the tool for maximum tightness.
To release the accessory, repeat Steps 1 and 2 above.
Fig. G
Fig. H
Fig. I
Bit Clip (Fig. A)

WARNING: To reduce the risk of serious personal
injury, turn tool off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
IMpoRTaNT: When attaching or replacing the bit clip
use only the screw that is provided. Be sure to securely
12
tighten the screw.
The bit clip can be be attached to either side of the tool
11
using only the screw provided, to accommodate left- or
12
right- handed users. If the bit clip is not desired at all, it can
be removed from the tool.
To move the bit clip, remove the screw
in place then reassemble on the opposite side. Be sure to
securely tighten the screw.
Operation

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
ENglIsH
4
,
11
that holds it
12
35