_ WARNING: Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
,_ WARNING: Always wear proper personal hearing protection
that conforms to ANSI $12.6 ($3.19) during use. Under some
conditions and duration of use, noise from this product may contribute
to hearing loss.
_ CAUTION: When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over
•
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V................... volts
A ...................... amperes
Hz................. hertz
min ............... minutes
---
or DC... direct current
Q ................. Class I Construction
(grounded)
[] ................. Class II Construction
(double insulated)
.../min ........... per minute
BPM ............. beats per minute
IPM............... impacts per minute
RPM ............. revolutions per
minute
sfpm ............. surface feet
per minute
SPM ............. strokes per minute
W..................... watts
"_ or AC .......... alternating
current
or AC/DC... alternating
or direct
current
no .................... no load
speed
n ...................... rated
speed
.................... earthing
terminal
..................... safety alert
symbol
Important
Safety
Instructions
for All
Battery
Packs
When ordering replacement battery packs, be sure to include the
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below and
then follow charging procedures outlined.
READ ALL INSTRUCTIONS
•
Do not
charge
or use the battery
pack
in explosive
atmospheres, such as in the presence of flammable liquids,
gases or dusL Inserting or removing the battery pack from the
charger may ignite the dust or fumes.
•
NEVER force the battery
pack into the charger. DO NOT
modify the battery pack
in any way to fit into a non-
compatible
charger as battery pack may rupture causing
serious personal injury. Consult the chart at the end of this
manual for compatibility of batteries and chargers.
•
Charge the battery packs only in designated DEWALT chargers.
•
DO NOT splash or immerse in water or other liquids.
•
Do not store or use the tool and battery
pack in locations
where the temperature
may reach or exceed 105 °F (40 °C)
(such as outside sheds or metal buildings in summer). For
best life store battery packs in a cool, dry location.
NOTE: Do not store the battery
packs in a tool with the
trigger switch locked on. Never tape the trigger switch in
the ON position.
i_ WARNING: Fire hazard. Never attempt to open the battery pack for
any reason. If the battery pack case is cracked or damaged, do not
insert into the charger Do not crush, drop or damage the battery pack.
Do not use a battery pack or charger that has received a sharp blow,