DeWalt DCD790 Manual De Instrucciones página 12

FIG. 3 FIG. 4 FIG. 5
1. Turn tool off and disconnect tool from power source.
2. Grasp the black sleeve of the chuck with one hand and
use the other hand to secure the tool. Rotate the sleeve
counterclockwise far enough to accept the desired accessory.
3. Insert the accessory about 3/4" (19 mm) into the chuck and
tighten securely by rotating the chuck sleeve clockwise with one
hand while holding the tool with the other. Your tool is equipped
with an automatic spindle lock mechanism. This allows you to
open and close the chuck with one hand.
Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
To release the accessory, repeat steps 1 and 2 above.
Belt Hook and Bit Clip (Fig. 2)
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
_WARNING: To reduce the risk of serious personal injury, DO
NOT suspend tool overhead or suspend objects from the belt hook.
ONLY hang tool's belt hook from a work belt.
11
_WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
IMPORTANT" When attaching or replacing the belt hook or bit clip,
use only the screw (H) that is provided. Be sure to securely tighten
the screw.
The belt hook (G) and bit clip (I)can be attached to either side of the
tool using only the screw (H) provided, to accommodate left- or right-
handed users. If the hook or bit clip is not desired at all, it can be
removed from the tool.
To move belt hook or bit clip, remove the screw (H) that holds it in
place then reassemble on the opposite side. Be sure to securely
tighten the screw.
OPERATION
_, WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 6) FIG. 6
NOTE" For best results, make
sure your battery pack is fully
charged, j
To install the battery pack (K)into \
the tool handle, align the battery
pack with the rails inside the tool's
handle and slide it into the handle K
until the battery pack is firmly
seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button (J)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.