Idiomas disponibles
Idiomas disponibles
Assembly
5.
Refit the cover.
When operating the device, the rear side
cover must be mounted.
7.3
Connecting the device to the
network
The unit must be connected to a network for
operation.
Purpose of the network connection
The network connection is used to exchange
information or control signals between the unit
and a software installed on a computer, in order
to, e. g.:
– Display parameters
– Select operating modes
– Indicate messages and error situations
– Change unit settings
– Activate test functions
– Transmit data for archiving
– Provide documents concerning the units
Combining devices safely
– The overall safety of the unit and its main per-
formance features are independent of the net-
work. The device is designed for operation
independent of a network. However, some of
the functions are not available in this case.
– Incorrect manual configuration can lead to sig-
nificant network problems. The expert knowl-
edge of a network administrator is required for
configuration.
– The device is not suitable for direct connection
to the public Internet.
20
|
EN
Take care when connecting units together or to
parts of other systems as there is always an ele-
ment of risk (e.g. due to leakage currents).
1.
Only connect units when there can be no
question of danger to operator or to patient.
2.
Only connect units when it is safe to do so
and when there is no risk of damage or harm
to the surroundings.
3.
If it is not 100% clear from the unit data
sheet that such connections can be safely
made or if you are in any doubt, always get a
suitably qualified person (e.g. the manufac-
turer) to verify that the setup is safe.
4.
Observe the specifications of IEC 60601‑1
(EN 60601‑1) when connecting the appli-
ance with other appliances, e.g. a PC sys-
tem, both in and outside the patient environ-
ment.
5.
Only connect peripheral units (e. g. com-
puter, monitor, printer) that conform at least
to the requirements set out in IEC 60950‑1
or IEC 62368‑1.
6.
The connected computer must conform to
EN 55032 (class B) and EN 55024.
Connecting the unit via the network cable
1.
Remove the cover from the back of the unit
using a suitable tool (e.g. slotted-head
screwdriver).
2137100008L02
2311V001
