Installation; Wassembling The Pan-Tilt Head - Panasonic AW-PH400E Manual De Instrucciones

Installation

(Be sure to ask your dealer to install the unit.)
w Assembling the pan-tilt head
When assembling the pan-tilt head, use the hexagon key wrench provided and a screwdriver to tighten up the parts at
the specified torque.
After mounting the pan-tilt head, check there is no play in its installation.
Attaching the camera mounting base
Attach the camera mounting base to the rotary arm using the
3 mounting screws (M5 M 22 mm, with flat washers) provided.
The installation direction differs depending on how the base is
installed.
Attaching the rotary arm
Attach the rotary arm to the rotary head using the 4 mounting
screws (M5 M 22 mm, with flat washers) provided.
The installation direction differs depending on how the arm is
installed.
For a stand-alone installation
Camera mounting base
For installation on the ceiling
p Change the guide pin and screw positions as shown in the figure below on the right, and then attach the camera mounting
base to the rotary arm.
p Tighten up the guide pins using a flathead screwdriver.
Rotary head
Attaching the base
Mounting screws (M5)
Rotary arm
Camera Mounting base
Rotary arm
Change the positions of the camera
mounting screws.
Camera mounting base
12 (E)
Indoor Pan/Tilt Head AW-PH400
Clamping torque
and arm
3.0 N
Guide pins (M4) 1.5 N
Rotary head
m (30 kgf cm)
• •
m (15 kgf cm)
• •
Change the positions
of the guide pins.