Trouble Shooting - Parkside PHD 170 C2 Traduccion Del Manual De Instrucciones Originale

Trouble shooting

Problem Possible cause
Standard Vario noz-
zle (25) soiled
Severe
pressure
fl uctuations
Block in standard
Vario nozzle (25)
ON / OFF switch
(8) is turned off
Pressure
cleaner is Damaged power
not operat- supply cable
ing
Mains fault
Pressure Air trapped in the
cleaner pressure cleaner
does not
generate
Drop in the water
any pres-
mains pressure
sure
Leaks in
Connections not fi t-
the water
ted correctly
system
Remedy
Rinse the standard Vario nozzle (25) with water.
Clean the nozzle bore hole with a needle (see chap-
ter entitled cleaning).
Remove the standard Vario nozzle (25) and ensure
that the water can discharge from the jet gun (14)
unimpeded. In other words, the device is working
perfectly. The turbo dirt miller (26) and the rotating
wash brush (21) do not normally get blocked.
Check ON / OFF switch
Switch off the equipment and disconnect from the
mains. Check power supply cable for damage. If
necessary have the power supply cable replaced by
a qualifi ed electrician.
Check the electrical system for conformity with the
data on the rating plate.
Switch on the equipment with the jet gun and with
no nozzle until bubble-free water comes out.
Check the water mains.
Switch off the equipment and disconnect from the
mains. Reconnect the equipment to the water pipes
(cf. "Initial Operation/Set-Up")
GB MT
31