Idiomas disponibles
Idiomas disponibles
GB
MT
Setting up
With the curved handle (2) pulled
out, you can conveniently roll the de-
vice.
• Pulling out the handle:
Pull the curved handle (2) upwards.
• Pulling in the handle:
Press the release button of the curved
handle (1) and push the curved handle (2)
downwards.
1. Place the device horizontally on a level
surface.
2. Insert the high-pressure hose (4)
through the guide for the high-pressure
hose (4.1).
3. Insert the high-pressure connector
for the spray gun (29) into the high-
pressure connection (27) on the spray
gun (14). Make sure that the hose does
not pass through the curved handle (2)
so as not to obstruct the curved handle
(2).
4. Connect the supply hose to the water
supply and bleed the hose by allowing
water to fl ow bubble-free out of the
other end of the supply hose. Close the
tap.
5. Insert the sieve insert (12.1) in the wa-
ter connection (13).
6. Mount the water connection coupling
(12) on the water connection (13).
7. Connect the feed hose with the help of
the quick connector for garden hose
adaptor (22) with the water connection
coupling (12) and the water connection
(13) on the device.
8. Connect the lance (3) to the spray gun
(14) by inserting it and screwing it in
(bayonet catch).
9. If the lance (3) is mounted, connect
either the standard vario-nozzle (25) or
turbo dirt blaster (26) by inserting into
the lance (3). The attachments snap
into place. To remove the attachments,
press the side lock (7) on the front end
26
of the lance (3) and pull the attachment
forwards to disconnect it.
10. Connect the rotating washing brush
(21) directly to the spray gun (14) by
inserting it and tightening (bayonet fi t-
ting). It is always used without applying
any pressure. The cleaning function is
produced by the rotational movement
and the fl ow of water. If there is no
water fl ow, the washing brush does not
rotate.
If you turn the tip of the standard
Vario nozzle (25) to the left you will
increase the width of the jet. If you
turn the nozzle tip to the right you
will reduce the width of the jet.
The roles of the unit, use the handle
(2) only in conjunction with the
wheels (11). For lifting and carry-
ing use the carrying handle (2).
Mains connection
The pressure cleaner you have acquired
is already fi tted with a mains plug. The
equipment is designed for connection to an
earthed wall socket with a RCD (Residual
Current Device) at 230 V~ 50 Hz.
Only operate the pressure cleaner
after all the above points have been
observed.
1. Ensure that the pressure cleaner is
turned off by its ON / OFF switch (8).
2. Insert the mains plug into the mains
socket
Operation
Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing fi rmly and that you
are holding the gun (14) se-
