Idiomas disponibles
Idiomas disponibles
Attach the grinding wheel (see
figure G H)
■ Press and hold down the spindle lock (1.).
■ Using the pin wrench, loosen the clamping
nut on the spindle in an anticlockwise
direction and remove (2.).
■ Insert the grinding wheel in the correct
position.
■ Screw the clamping nut with flange face
up, onto the spindle.
■ Press and hold down the spindle lock.
■ Tighten the clamping nut with the pin
wrench.
■ Carry out a test run to check that the tool is
clamped in the centre.
Test run
■ Insert the battery.
■ Switch on the angle grinder with the switch
(without engaging it) and run the angle
grinder for approx. 30 seconds. Check for
imbalances and vibrations.
■ Switch off the angle grinder.
Switching on and off (see figure I)
The main switch has a secondary LOCK-OFF
tab that must be rotated to the front to be
able to depress the power switch.
■ Grasp the main switch with your fingers
and slide the tab to the front (1.).
■ Depress the main switch (2.) to activate the
angle grinder.
■ Release the main switch to stop the angle
grinder.
NOTE
Following a power failure, the switched on
power tool does not restart.
Adjusting the guard (see figure J)
To adjust the tool to the task at hand, the
guard hood can be adjusted by 12 notches
on 360° without a tool.
CAUTION!
Risk of injury! Wear protective gloves.
■ Remove the battery.
■ Turn guard hood opposite to the direction-
of-rotation arrow on the gear head to the
required position.
18
Work instructions
NOTE
When the power tool is switched off, the
grinding tool continues running briefly.
Rough-grinding
WARNING!
– Applying moderate pressure, move the
angle grinder backwards and forwards. As a
result, the workpiece will not become too hot
and there will be no discoloration; nor will
there be any grooves.
Maintenance and care
WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning ( see figure K)
■ Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
■ Regularly blow out the housing interior and
motor with dry compressed air.
■ Regularly clean the filter cover.
■ Remove filter cover and blow it out with dry
compressed air.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period. Non-compliance
will deem the guarantee obligations of the
manufacturer null and void.
Repairs
Repairs may be carried out by an authorized
customer service centre only.
Spare parts and accessories
For other accessories, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com.
LBP 125-15 18-EC
