Flex LBP 125-15 18-EC Instrucciones De Funcionamiento Originales página 17

LBP 125-15 18-EC
Overview (see figure A)
1 Spindle
2 Threaded flange
a Clamping flange
b Clamping nut
3 Guard hood
Can be adjusted without a tool through
360° by means of 12 notches.
4 Spindle lock
Secures the spindle when the tool is
changed.
5 Gear head
With air outlet and direction-of-rotation
arrow.
6 Power Switch
The power switch energizes the unit
when it is depressed.
7 Lock-Off Tab
The ambidextrous tab must be rotated to
the front to activate the power switch.
8 Rear handle
9 Filter cover
10 Handle
Handle can be fitted to the left or right.
11 Pin wrench
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the angle grinder and check that there
are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.
Inserting/replacing the battery
(see figure B)
■ Press the charged battery into the power
tool until it clicks into place.
■ To remove, press the release button (1.) and
pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short-
circuit the contacts; explosion and fire hazard!
Battery state of charge (see figure C)
■ Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds. If
one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after
the button is pressed, the battery is faulty and
must be replaced.
Attach and remove the guard
WARNING!
When using the angle grinder for roughing
or cutting, never work without the guard.
A special cutting guard must be used for
cutting.
To attach (see figure D)
■ Remove the battery
■ Attach the guard (1.). Lugs on the guard
hood must be located in the flange
recesses.
■ Turn guard hood clockwise (2.). Rotation is
possible in one direction only!
To remove (see figure E)
■ Remove the battery
■ Rotate the guard clockwise, and it will pop
up when it reaches a certain position.
■ Rotate the guard counterclockwise for a
small angle (1.) and take it out along the
recesses of the flange (2.).
Attach the handle (see figure F)
NOTE
It is not permitted to operate the electric
power tool without the handle.
Attaching/changing the tool
■ Remove the battery.
17