Work Instructions; Maintenance And Care - Flex L 26-6 230 Instrucciones De Funcionamiento Originales

Loosen the clamping lever (1.).

Adjust the guard (2.).

Retighten the clamping lever (3.).

Adjusting the switch handle
The switch handle can be rotated from the
middle position by 90° in either direction.
Press the release button (1.) and simul-

taneously rotate the switch handle (2.).
Release the button.

Ensure that the release button is
engaged in the respective end position.

Work instructions

NOTE
When the power tool is switched off,
the grinding tool continues running briefly.
Rough-grinding
WARNING!
Never use cutting-off wheels for rough-
grinding.
22
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING!
A special cutting guard must be used for
cutting.
See manufacturer's accessories catalogue.
– Do not press, tilt or oscillate the power tool.
– The angle grinder must always be
operated backwards.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of the
groove.
– Adjust the feed to the material which is to
be cut: the harder the material, the slower
the feed.
For further information on the manufac-
turer's products go to www.flex-tools.com.

Maintenance and care

WARNING!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Cleaning
WARNING!
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing. Impairment of
the protective insulation!
L 26-6 230