Auto Stimulation Mode - cefar PRIMO PRO Manual De Instrucciones

AUTO STIMULATION MODE

To provide a pain relieving effect, the level of stimulation should be perceived as a little bit stronger than
the pain intensity. Since the body initially adapts to the set level of stimulation, it is often required to
46
adjust the amplitude a couple of times to reach the optimal level of stimulation.
By using the Auto stimulation mode the amplitude is automatically adjusted, and the optimal level is
reached after a few minutes of stimulation.
To use the Auto stimulation mode:
Follow steps 1-4 in the section STEP-BY-STEP USE.
5. START THE AUTO TEST
Press the AUTO button
for the left or right channel. "AUTO" starts flashing on the display,
AUTO AUTO
and the amplitude increases gradually.
S
P
6. FINISH THE AUTO TEST
Press the AUTO button again when you feel the stimulation at a comfortable level.
AUTO AUTO
S
P
If you press AUTO too late, or want to start again for any reason, press the AUTO button again to start
over.
7. REPEAT THE AUTO TEST FOR THE OTHER CHANNEL
If you want to use the Auto stimulation mode for both channels, repeat steps 5-6 for the other channel.
8. THE STIMULATION STARTS
The program starts after a few seconds, and the amplitude is automatically adjusted to an optimal level
of stimulation.
Even if you use Auto stimulation mode, you can increase or decrease the amplitude at any time by
pressing the INCREASE or DECREASE buttons
until the stimulation feels pleasant. If doing
so, the automatic amplitude setting is lost.
AUTO AUTO
S
P