cefar PRIMO PRO Manual De Instrucciones página 45

5. START THE STIMULATION
Press the INCREASE button
for each channel until you
reach a comfortable level of stimulation. Press and hold the but-
45
ton to increase the amplitude continuously.
AUTO AUTO
Note! Always increase the amplitude cautiously!
S
P
Note! Program 5 (mixed frequency): Set the amplitude for conventional stimulation (80 Hz) when
the upper part of the high/low frequency symbol is flashing. When the stimulator after 3 seconds
switches over to burst stimulation (2 Hz) and the bottom part of the symbol is flashing, set the ampli-
tude for this frequency. The frequencies switch every three seconds.
The treatment time is preset, but can be changed by using the timer function, see section TIMER.
An automatically activated key lock prevents unintentional changes during treatment. The key lock is
activated if no button is pressed for 10 seconds. Press any of the DECREASE buttons
to deactivate
the key lock.
When the program is finished, Remaining time "00:00" is flashing on the display.
AUTO AUTO
S
P
The last used programs are saved when the stimulator is turned off and then pre-selected the next time
the stimulator is turned on.
The stimulator turns off after 5 minutes of inactivity to spare batteries.