Idiomas disponibles
Idiomas disponibles
ENGLISH
-
ODO (odometer): it shows the total distance travelled since the first use of the bicycle.
Range: 0-999.9 km/h.
-
SCAN (scan): when the SCAN icon flashes, functions will be shown one by one.
Button functions
-
Press the button to switch on the console.
-
When the SCAN icon flashes, functions will be shown one by one. Press the button again,
the SCAN icon will disappear. The function being displayed will remain fixed, i.e. the other
functions will no longer be displayed one by one. By pressing the button again you can
choose the function you wish to display at any given moment.
-
Pressing and holding the button for 2 seconds will reset the values to zero (except for
the ODO function). The values of the ODO function will only be reset when you change the
battery.
-
Issues requiring attention:
-
If the bicycle has not been used or no operation has been performed on the console for 4
minutes, then the console will automatically switch off.
-
If the bicycle is used again or if you press the button, the console will automatically switch
on again.
5. INFORMATION ON EXERCISING
A proper workout should consist of the following three phases:
-
Warm-up: consists of a session of stretching and low-intensity exercise lasting 5 to 10
minutes. A proper warm-up increases your body temperature, heart rate, and circulation
in preparation for exercise. Fig. 14
-
Training: consists of 20 to 30 minutes of exercise.
(Note: during the first few weeks of exercise do not keep your heart rate high for more than 20
minutes). Fig. 15
Cool-down: consists of 5 to 10 minutes of stretching exercises. This will increase the
-
flexibility of your muscles and will help prevent injuries. Fig. 14
6. CLEANING AND MAINTENANCE
-
Lubricate the moving parts periodically to prevent premature wear.
Inspect and tighten all parts before using the machine. Replace any defective parts
-
immediately, and do not use the equipment again until it is in perfect working condition.
-
The machine can be cleaned using a slightly damp cloth and mild non-abrasive detergent.
Do not use solvents.
Avoid exposing the machine to direct sunlight, especially the console.
-
54
-
Do not try to repair the machine by yourself. Should you have any difficulty with the
assembly or operation of the exercise bike, or if you think that any part is missing, contact
the official Cecotec Technical Support Service.
To move the machine, either pull down on the handlebars until the rear of the bike is in the
-
air or lift the bike by grasping the rear stabiliser. This allows you to move the bike to the
desired position in complete safety.
Note:
The cleaning and maintenance frequency depends on the use frequency and intensity.
7. TROUBLESHOOTING
Problem
Possible causes
The machine wobbles
Feet are not level.
during use
1. The battery is dead.
The console does not work
2. Cables are connected
properly
incorrectly.
The handlebar is not stable
The bolts are loose.
Loud noise from moving
The parts are not tightened
parts
properly.
8. TECHNICAL SPECIFICATIONS
Product reference: 07222
Product: Drumfit Static 6000 Seat
Maximum user weight: 120 kg.
HC Class
Dimensions: 140x64x103 cm
Weight: 23 kg
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
ENGLISH
Solution
Rotate the feet until the bike is
level.
1. Change the battery.
2. Connect them properly.
Tighten the bolts.
Tighten them.
55
DRUMFIT STATIC 6000 SEAT
