Idiomas disponibles
Idiomas disponibles
7. TABLE
1.
Fasten the bracket to the cabinet using the screws provided for this purpose. . Grasp the bottom edge
of the shelf and turn it upwards, until it is in horizontal position. . Push the edge downwards towards the
tank until it is blocked into position (see figure 6).
8. CONNECTION TO THE MAINS
1
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance.
2.
Ensure that the supply socket has the following characteristics:
b)
earthed.
It fulfils the requirements of the rated current as set out on the rating plate.
the IEC regulations: - magnetothermal differential switch with In = nominal value as stated on the rating
plate;- Differential with Id sensitivity = 30 mA.
room.
4.
The connecting cable to the appliance is H05 VVF, designed for internal use. . Connect the
plug (do not use three-way adapters and reduction adapters) (see figure 7).
9. CONTROLS
The controls of the appliance are located at the front inside a protected panel.
display the temperature in the upper cabinet.
Press button
5 "SET or P"
button
6 "UP"
or button
7 "DOWN 2. Refrigeration unit switch:
3. Light switch:
to switch on the internal lights.
cabinet.
Thermostat:
to adjust the temperature in the lower cabinet (see figure 8).
10. CHECKING CORRECT OPERATION
Check that: 1
. The plug is connected. . The refrigeration unit switch is switched on (green light on).
3
. The thermometer shows the desired temperature for the goods to be stored.
exposed to direct sunlight or to high-powered lamps. . The room temperature does not exceed that in
which the appliance is designed to work normally, i.e. +30°C, 55% r.h. (climatic class 4).
11. REPLACING THE LAMPS
1
. Switch off the appliance.
glass protective cover using a screwdriver.
socket. . Remove the lamp socket, whilst holding the fluorescent tube and the transparent protective
4
tube. . Slide out the tube and the protection from the other lamp socket that is still in position. . Replace
5
the fluorescent tube.
7.
Replace everything in reverse order.
unscrew the lamp socket. . Remove the lamp socket, supporting the fluorescent tube.
out from the lamp socket still in position.
reverse order (see figure 9).
Operator's guide
3
. Ensure that there is no danger of explosion (AD) in the
Thermostat
once to display the temperature set-point, which can be changed by pressing
".
4. Thermometer:
2
2.
If the tank light bulb needs to be replaced, first of all remove the frosted
3.
Unscrew the two screws of the right-hand or left-hand lamp
9
11.
Replace the fluorescent tube.
3
: to adjust the temperature in the upper cabinet.
to switch on the refrigeration unit.
to read the temperature in the lower
5
8.
If the other lamp needs replacing,
12.
7
2
(A)
attached
a)
it is properly
c)
It complies with
5
1. Thermometer:
to
4.
The appliance is not
6
10
. Slide the tube
Replace everything in
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
