Idiomas disponibles
Idiomas disponibles
.qFRVICF AND A_r}JUSTMEN FS
FR|CTION
WHEEL
BOLT
TO REPLACE FRICTION WHEEL
Ifthe snowthrower will not move forward,and the friction
wheel is worn or damaged, you need to replace it as
follows: (First allow the engtne to cool.)
AWAY FROM FIRE OR FLAME,
!
•
Drain the gasoline from the fueltank by removing the
fuel line Drain the fuel and reinstall the fuel line.
•
Disconnect the spark plug wire
•
Stand the snow thrower up on the auger housing end
(See Fig 33).,
•
Rerr_ve the bottom panel (See Fig,,30, page 21).
®
Remove the three (3) fasteners securing the fnction
wheel to hub (See Fig..32) and set fasteners aside
•
Remove the four bolts securing the bearing plates
(both sides)
•
Remove right side bearing plate Leave Hex shaft in
original position (See Fig..33).
®
Rernove fdction wheetfrom hub Slipfrictionwheel off
hex shaft towards right side (See Fig 33)
•
Position new friction wheel onto hub,
•
Install bearing plates to original position Ensure hex
shaft is engaged with both bearing plates,
•
Secure bearing plates using bolts removed earlier.
•
Secure friction wheel to hub using fasteners removed
earlier. Ensure hex shaft turns freely,
NOTE: Ensure frictionwheel and friction disc are free
from grease or oil.
•
Replace bottom panel
•
Lowerthe snow thrower ontothe tires
LOCKWABHER
HUB
NUT
FIG. 32
FRICTION
HUB
HEX
SHAFT
BOLT
LOCKWASHER
HEX SHAFT
FASTENERS
(screws,
Iockwashers
RING
and nuts)
PLATES
;
"\
0
•
//
i, . ...................................................................
ous,NG
(UNIT STANDING ON
AUGER HOUSING END)
j
Hi,ll
===ul,Jlu
FIG. 33
22
