Idiomas disponibles
Idiomas disponibles
ASSEMBLV
HOW TO SET UP YOUR SNOW
THROWER
@ Your snow thrower is equipped with height adjust
skids (See Fig 2) on the outside of the auger
housing, To adjust the skid height for different
conditions, see To Adjust Skid Height paragraph on
page 18,
TO INSTALL THE UPPER HANDLE
AND CRANK ASSEMBLY
•
Remove the screws, flatwashers, Iockwashers, and
hex nuts securing the shifter plate in the lower holes
of the tower handle and move shift lever to 3rd gear
(See Fig 4A)
•
Loosen, but do not remove, the screws, flatwashers,
Iockwashers, and hex nuts in the upper holes of the
lower handle
I
Raise upper handle into operating position Upper
handle should be to the outside of the lower handle
and shifter plate to the inside
I
Replace the right hand screw, flatwasher,iockwasher,
and hex nut throughthe handle and shifter plate Do
not tighten until all bolts are in place.
NOTE: Unless you have the assistance of another per'-
son, it may be easier to install one side of the handle at a
time
i
Remove the 3/8" nylon Iocknut and flatwasher from
the eye bolt assembly (on the chute crank assembly
removed earlier). Check to make sure the two 3/8"
jam nuts are tight The jam nuts should be 2 75 inches
from the end o{ the eye bolt (See Fig 4B)
•
Remove the plastic bag, the plastic cap, the cotter pin
and the washer from the crank assembly and set
aside (See Fig 5)
I
Rotate the notched section of the discharge chute
toward the crank-adjusting rod (See Fig, 5),
@ Install the wormed end of the crank throughthe hole
in the adjusting rod and secure the end with the
flatwasher and cotter pin, as shown in Fig 5
@ Bend the ends of the cotter pin around the rod and
reinstall the plastic cap.
•
install eye bolt throughlower hole in theleft hand side
of the handle and shifter plate (See Fig 4B)
I
install the 3/8" tlatwasher and the 3/8" nylon Iocknut
loosely on the eye bolt as shown in Fig 4B
I
Tighten nut on eye boft installedearlier, keeping eye
in line with the rod while tightening the inside se-
curely
i
Tighten the screw, flatwasher, lockwasher and hex
nut at the tower right hand hole (See Fig 4A)
5/16"
LOCKWASHER
UPPER
HANDLE'_,
UPPER
11f32"
FLATWASHER
X 2-3/4'"
PLATE
FIG 4A
ADJUST
NUTS TO
MOVE
EYE BOLT
IN
OUT
EYE
BOLT
BOOT
318""
FLATWASHER
FIGo 4B
NYLON
LOCKNUT
3/8 4
FLATWASHER
ADAPTER
PLAST,C
\
\
.NOTC.E{ SECTiON
CAP
COTTER tt,,,,'_ t18
- PiN
INCH CLEARANCE_
_,,_
FLA
L<.
i
_
\, ".. .//S"'._
_/zINCH
RG_ 5
NOTE: Make sure the cabtes are not caught between the
upper and lower handle
•
Tighten two upper handle bolts
•
Rotate the chute crank fully clockwise and tully
counter-clockwise
The discharge chute should ro-
tate futly with approximately 1/8 inch clearance
8
