Idiomas disponibles
Idiomas disponibles
,JJl,i
SNOW THROWER
LUBRICATION
- EVERY
FIVE HOURS
®
Lubricate the flange on the discharge chute every
five (5) hours during use and before storage (See
Fig 17),
•
See Lubrication Chart diagram on page 15 for
lubrication points and type of lubricant
LUBRICATION
- EVERY
TEN HOURS
•
Auger Shaft- For storage, lubricate auger shaft ( See
Fig 16) with a clinging type grease such as Lubriplate,
When replacingshear bolts, remove shear bolts and
lubricate auger shaft (see To Replace Shear Bolt
paragraph on page 23)
•
The chute control rod, used to change the direction
of the snow discharge, needs to be lubricated
frequently and before storage (See Fig 17)
•
See Lubrication Chart diagram on page 15 for
lubricationpoints and type of lubricant
LUBRICATION
- EVERY
25 HOURS
CUSTOMER RESPONSIBILITIES
lull
i
II
i
II i,illl
i lll
i _LL-
_
AXLE
AXLE _
FIG. 15
•
Position
speed selector lever in first gear
•
Place a coin or (a shim of equal thickness) between
the rubber
friction
wheel and disc drive plate to
prevent friction wheel contacting
the friction disc
•
Disc Drive Plate- Using a hand grease gun lubricate
wit h a Hi Temp EP Moly grease, zerk iocated beneath
the disc drive plate (See Fig 18 inset) every 25 hours
and at the end of the season and/or before storage.
To grease
zerk, turn disc drive plate clockwise
by
hand until zerk is clearly visible at front cer_ter DO
NOT overfill or allow grease
to come in wheel or
damagewill
result Fill zerkontyuntiigrease
becomes
visible below bearing assembly located under grease
zerk
See Lubrication
Chart on page 15
II
IMPORTANT:
Remove coin and ensure
that a gap
exists
between
friction
wheel
and
disc
drive
plate.
®
NOTE:
Clean all excess grease
lound on friction
disc hub.
LUBRICATEAUGER'SHAFT
FIG. 16
DISCHARGE
CHUTE
FLANGE
CHUTE
CONTROL
ROD
FIG. 17
LUBRICATION
•
Hex Shaft and Gears - Hex shaft and gears requ[re
no lubrication All bearings and bushings are lifetime
lubricated and requireno maintenance (See Fig, 18),
t)
CAUTION: Do not allow grease to contact friction
wheel and disc drive plate
LUBRICATION
- BEFORE
STORAGE
®
Remove both wheels, grease (any automotive type
grease) both axles (See Fig 15) and replacewheets.
Do this at least once a year and/or prior to storage,
NOTE: Any greasing or oiling of the above components
can cause contamination of the friction wheel If the disc
drive plate or friction wheel come in contact with grease
or oil, damage to the friction wheel will result
Should grease or oil come in contact with the disc drive
plate or friction wheel, be sure to clean the plate and
wheel thoroughly.
NOTE: For storage, the hex shalt and gears should be
wiped with 5W-30 motor oil to prevent rusting (See Fig
18)
16
