Idiomas disponibles
Idiomas disponibles
ASSE
LY
@ Rotate the chute crank fully clockwise and fully
counter-clockwise. The discharge chute should ro-
tate fully with approximately 1/8 inch clearance be-
tweenthe worm and the bottom of the notch (See Fig.
5)
®
If the chute crank needs to be adjusted, go to lhe
Service and Adjustments section on page 18.Screws
securing chute clips at the base of the chute should
be slightly loose for easy rotation.
NOTE: Be sure the crank does not touch the side of the
engine or the cover will be scratched
TO INSTALL SHIFTER
LEVER KNOB
®
Thread the shifter lever knob ontothe threaded end
of the shifter lever until it is snug against the hex nut
and the lip is pointed toward Ihe engine. Tighten the
hex nut against the bottom of the shift lever knob (See
Fig. 6)..
SHIFTER KNOB
LEVER
FIG. 6
TO CHECK/ADJUST
CLUTCH
CONTROL
CABLES
The control cables, Fig. 7, attached to the auger clutch
lever and traction clutch lever may need to be adjusted
before you use your snow thrower.
For instructions on checking or adjusting the control
cabies, see ToAdjust Clutch Contro_Cables paragraph on
page 19.
TRACTION CLUTCH LEVER
AUGER CLUTCH LEVER
CONTROL CABLES
FIG.7
4' CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
SNOW THROWER, WE WISH TO ASSURE THAT YOU
RECEIVE
THE
BEST
PERFORMANCE
AND
SATISFACTIONFROM THISQUALt7-Y PRODUCT
PLEASEREVIEW THEFOLLOWING CHECKLIST:
,l
A_Iassemblyinstructions h ave been completed
/
The discharge
chute rotates freely
/
No remaining loose parts in
carton
WHILE LEARNING HOW TO USE YOUR SNOW
THROWER,
PAY EXTRA
ATTENTION
TO
THE
FOLLOWINGIMPORTANTITEMS
/,/' Engine oilis at proper level
/4' Make sure gas tank is filled properly with clean, fresh,
unleaded
gasoline,
v'/ Become familiar with all controls-their ]ocation and
function
Operate
controls
before starting
engine
9
