Idiomas disponibles
Idiomas disponibles
Laser Distance Meter/ English
Figure H
Indirect Measurement - Determining a Distance Using 3
Measurements (See"Figure H")
Press this button
twice; the display shows the
distance to be measured flashes in the symbol.
Aim at the lower point (1) and trigger the measurement.
After the first measurement the value is adopted. Keep the instrument
as horizontal as possible.
Press to measure the distance result of the horizontal point (2).
Press to measure the distance result of the upper point (3).
The result of the function is displayed in the summary line.
Figure I
Historical Storage
the previous 20 records (measurements or calculated results) are
shown in reverse order. Use the
these records.
You can clear all records by pressing the Storage button and the Clear
button simultaneously in historical storage mode.
8
symbol, The
or
buttons to navigate through
Timer (self-triggering)
Press this button to set a 5-second time delay.
Press and hold down this button until the desired time delay is
reached(max. 60 seconds).
Or you can use
button to change time delay.
Press this button, remaining seconds until measurement (e.g. 59, 58,
57...) are displayed in a countdown.
The last 2 seconds will flash and beep faster. After the last beep
the measurement is taken and the value is displayed.
Bluetooth
Switching on BLUETOOTH / sending measurements
Press and hold until the Bluetooth symbol appears in the display.
Then you can use our Meterbox APP installed on your phone to connect
this instrument.
Whilst the first connection between the phone/ PC and the Laser
distance meter is being established, a prompt for the Pin-code of the
instrument may be displayed. In this case, enter the code 0000 into your
phone/pc.
Switching off BLUETOOTH
Press and hold until the Bluetooth symlol disappears in the display.
The BLUETOOTH switches off as soon as the instrument is switched
off.
Stake out function (See "Figure K")
Two different distances (a and b) can be entered
into the instrument and can then be used to
mark off defined measured lengths, e.g. in the
construction of wooden frames.
Laser Distance Meter/ English
Figure K
9
