Idiomas disponibles
Idiomas disponibles
Laser Distance Meter/ English
Continuous laser
Press and hold down the laser active character appears permanently in the
display and a beep sounds. Every further press of the key releases a distance
measurement. You can switch the continuous laser function on or off by press this
button longer.
Or you can press the key to switch the device and laser continuous operation
off.
If the laser is in continuous operation mode, the laser automatically switches off
after 3 minutes.
Continuous Measurement (Tracking)& Max and Min Measurement
(See "Figure G")
The continuous measurement function (tracking) is used for the transferring of
measurements, e.g., from construction plans. In continuous measurement mode,
the measuring tool can be moved to the target, whereby the measured value is
updated approx. every 0.5 seconds in the third line. The corresponding minimum
and maximum values are displayed dynamically in the first and second line.
As an example, the user can move from a wall to the required distance, while
the actual distance can be read continuously. For continuous measurement, push
button
until the indicator for continuous measurement appears in the display.
And press MEAS or Clear button again to stop the function. The function is
terminated automatically after 100 continuous times measurement.
MIN
Figure G
6
5. Functions
Addition / Subtraction
Distance measuring.
The next measurement is added to the previous one.
The next measurement is subtracted from the previous one.
The last step is cancelled.
Return to the single distance measurement.
Area Measurement
Press the Area/Volume button once. The
Press
Press
The result of the function is displayed in the summary line.
Volume Measurement
For volume measurements, push Area/Volume button twice until the
for volume measurement appears in the display.
The result of the area measurement from the values already measured and is
displayed in the summary line.
MAX
Indirect Measurement
Indirect measurement - determining a distance using 2 auxiliary measurements.
e.g. when measuring heights that require the measurement of two or three
measurements as following step:
press this button
flashes in the symbol.
After the first measurement the value is adopted. Keep the instrument as
horizontal as possible.
The result of the function is displayed in the summary line.
button to take the first length measurement (e.g. length).
again to take the second length measurement (e.g. width).
Press to take first distance measurement (e.g. length)
Press to take second distance measurement (e.g. width)
Press to take the third distance measurement (e.g. height)
(See "Figure H")
once , the display
shows . The distance to be measured
Aim at the upper point (1) and trigger the measurement.
Press to measurement the distance result of the horizontal point (2).
Laser Distance Meter/ English
symbol appears in the display.
indicator
7
