Idiomas disponibles
Idiomas disponibles
Pull the recoil starter lightly 1-3 times
Pull the recoil starter strongly to star the engine
If the engine stops after a few revolutions, set the choke to half open, and pull the recoil starter rope strongly
again to restart it. Note: if the engine does not catch even after the starter is pulled several times, set the
choke lever to full open and pull the starter rope. Be sure not to pull the starter lever completely out. After
the engine starts, open the choke lever slowly, move the throttle lever to the low-speed side, and let the
sprayer warm up fot 2-3 minutes-
Pull briskly
Start rope
Recoil starter
OPERATION
When the engine start
and pump is suctioning
When low
When high pressure
pressure spraying
STARTING
is required.
is necessary
HERBICIDE
HIGH PRESSURE
¡ES
INSECTICIDE
9
va
Noral sirios
Me
1 - Turn the handle of the control valve and set it
to the position for HERBICIDE, INSECTICIDE or
HIGH PRESSURE to match the pressure to
operating conditions.
2 — Check spraying conditions and the status of the equipment, then shoulder the equipment and set the
throttle lever to the high speed position.
3 — When the nozzle cock is opened, chemicals will be atomized as they come out of the nozzle.
IMPORTANT
When the pressure control valve andel is changed to INSECTICIDE or HERBICIDE, with the throttle being fully
open at HIGH PRESSURE position of pressure control handle, the engine speed will become too high, correspnd-
ing to the extent of lowered pressure. Therefor, use the equipment with the throttle lever some what tumed back
from the fully opened condition, when the equipment is used at the position for INSECTICIDE or HERBICIDE.
Be careful of the amount of fuel in the fuel tank, and refill it when it becomes low.
-12-
Pressure control valve handle
