Delta 36-R31 Manual De Instrucciones página 12

P
C
10. Insert the front end of the splitter (P) Fig. 18 inside the
splitter mounting bracket behind the splitter fastener
plate and the screw (C). Push the splitter down as far
as possible, making certain that the bottom edge of
the splitter (P) is parallel with the table surface. Tighten
the screw (C). Fasten the splitter and the blade guard
assembly (P) Fig. 19 to the bracket (M), using a 5/16-18 x
1" hex-head screw (V) and 5/16" flat washer (O).
11. IMPORTANT: The splitter (P) Fig. 20 has a notch (W) in
the top edge. Raise the front of the blade guard (G) Fig.
20, until the rear edge of the guard slips into notch (W) of
the splitter. This notch keeps the blade guard in the raised
position.
12. Attach the saw blade with the teeth pointing down at the
front of the saw table (Fig. 21). Attach the outside blade
flange and arbor nut (X). With the open end wrench (Y) on
the flats of the arbor, tighten the arbor nut by turning the
box-end wrench (Z) clockwise.
13. Use a straight edge (A) Fig. 22 to align the splitter (P) with
the saw blade (B). Use a square (C) Figs. 23 and 24 to
check the 90 degree angle of the saw blade and splitter to
the table surface. When all alignments are correct, tighten
the hardware (D) Fig. 24.
P
Fig. 18
B
A
Fig. 22
O
M
X
Fig. 23
12
P
V
G
P
W
Y
Z
C
B
Fig. 19
Fig. 20
Fig. 21