Cutting Equipment - Jonsered BC 2126 Manual De Instrucciones

GENERAL SAFETY PRECAUTIONS
For mufflers, it is very important that you
follow the instructions on checking, main-
taining, and servicing your machine.
Never use a machine that has a faulty
muffler.
0
Regularly check that the muffler is securely
attached to the machine.
_ WARNING:
Mufflers fittedwith
catalytic converters get very hot dur-
ing use and remain so for some time
after stopping. This also applies at
idle speed. Contact can result in
burns to the skin. Remember the risk
of fire!
_ WARNING:
The inside of the
muffler contain chemicals that may
be carcinogenic. Avoid contact with
these elements in the event of a
damaged muffler.
_1 WARNING:
Bear in mind that:
Engine exhaust fumes contain car-
bon monoxide, which can cause
carbon monoxide poisoning. For
this reason you should not start or
run the machine indoors, or any-
where that is poorly ventilated.
The exhaust fumes from the engine
are hot and may contain sparks
which can start a fire. Never start
the machine indoors or near com-
bustible material!
Locking nut
A locking nut is used to secure some types
of cutting attachment.
When fitting, tighten the nut in the opposite
direction to the direction of rotation of the
cutting attachment. To remove it. undo the
nut in the same direction as the cutting at-
tachment rotates. (CAUTION! The nut has
a left-hand thread.) Tighten the nut using
the socket spanner.
The nylon lining inside the locking nut must
not be so worn that you can turn it by
hand. The lining should offer a resistance
of at least 1.5 Nm. The nut should be re-
)laced after it has been put on approx. 10
times.
Cutting equipment
This section describes how to choose and
maintain your cutting equipment in order to:
• Reduce the risk of blade thrust.
• Obtain maximum cutting performance.
• Extend the life of cutting equipment.
IMPORTANT!
Only use cutting attachments with the guards
we recommend! See the section on
"Technical data".
Refer to the instructions for the cutting attach-
ment to check the correct way to load the
trimmer line and the correct line diameter.
Keep the teeth of the blade correctly sharp-
ened! Follow our recommendations. Also re-
fer to the instructions on the blade packaging.
Maintain the correct blade setting! Follow our
instructions and use the recommended file
gauge.
_ WARNING:
Always stop the en-
gine before doing any work on the
cutting attachment. This continues
to rotate even after the throttle has
been released. Ensure that the
cutting attachment has stopped
completely and disconnect the
lead from the spark plug before
you start to work on it.
_lb WARNING:
Using an incorrect
cutting attachment or an incorrect-
ly sharpened blade increases the
risk of kickback.