Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-1029-004.book Page 16 Thursday, June 9, 2016 9:53 AM
Battery Charging (Accessory) (see figure A)
Use only the battery chargers listed on the accessories page.
Only these battery chargers are matched to the lithium ion battery of your cord-
less worklight.
Note: The battery supplied is partially charged. To ensure full capacity of the bat-
tery, completely charge the battery in the battery charger before using your power
tool for the first time.
The lithium-ion battery can be charged at any time without reducing its service life.
Interrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
Do not continue to press the On/Off switch after the cordless
worklight has been automatically switched off. The battery can be
damaged.
To remove the battery 3, press the battery unlocking button 4 and pull the battery
out of the cordless worklight toward the rear. Do not exert any force.
Observe the notes for disposal.
Inserting the battery
Insert the charged battery 3 into the handle until it can be felt to engage and faces
flush against the handle.
Switching On and Off
The cordless worklight produces a light beam that emerges from
the lamp head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Starting Operation
16
