Buffalo CU489 Manual De Instrucciones página 8

EN
Troubleshooting
If you find any faults not listed here, please Call Buffalo agent or qualified technician.
Fault
Power indicator (red LED)
remains inactive
Unit is very noisy during
operation
Power indicator (red LED)
flashes and an acoustic
signal sounds
Power indicator (red LED)
and filter indicator
(green LED) flash and an
acoustic signal sounds
Appliance does not start
Line fuse /Ground fault
circuit fuse (GFCI)
blow-out
Low filtration
performance
Oil splashed sideways
and /or at the back of the
pump-filter unit
8
CU489_ML_A5_v2_20231010.indb 8
Probable Cause
• Power cord not plugged in
• Power cord defective
• Device defective
• Star handles are loose
• Rotor defective
• Rotor scratches on the fryer
• Over-temperature
• Appliance is at an angle of
more than 17°
• Strong vibrations caused by
Filter not closed properly
• Strong vibrations caused by
damaged rotating parts
• Control unit defective
• Power cord or other electrical
components defective
• Rotor defective /blocked
• Circuit overloaded
• Particle filter is full
• Pump-filter unit clogged
• Filter paper not inserted
properly
• Motor defective
• Particle filter full
• Too much space between
filter cover and pump-filter
unit
• Filter paper not inserted
overlapping
Solution
• Plug in the appliance
• Call Buffalo agent or qualified
technician
• Call Buffalo agent or qualified
technician
• Tighten star handles
• Call Buffalo agent or qualified
technician
• Change the position of the appliance
in the deep fryer
• Let the appliance cool down.
• Place the appliance in a cool place
• Check position of the appliance in the
fryer
• Switch off the machine and close
filter properly
• Please contact service
• Call Buffalo agent or qualified
technician
• Call Buffalo agent or qualified
technician
• Call Buffalo agent or qualified
technician
• Change socket/circuit
• Change particle filter
• Empty pump-filter unit; Boil out to
remove heavy dirt
• Insert filter as described
• Call Buffalo agent or qualified
technician
• Change particle filter
• Please contact service
• Insert particle filter as described
2023/10/10 17:31:34