Proxxon RBS/A Instrucciones De Servicio página 10

mounting of the movable components for maxi-
mum long-life and quiet running.
Powerful batteries in lithium-ion technology
and 2.6 Ah capacity guarantee continuous, high
performance work. To charge the battery, it is
simply inserted into the charger and is ready
for operation again within approx. 1 hour. For
your safety the process is thermally monitored.
Practical: the fl at end cap allows the device to
be vertically installed.
1 Key (Fig. 1)
1. Rotational speed regulating knob with
2. On/Off switch
3. Battery
4. Battery release button
5. Adapter for dust extraction
6. Driving roller
7. Grinding head to belt guide
8. Stretcher
9. Tightening roller
10. Grinding belt
11. Adjusting screw for belt running
12. Locking button
13. Charger
2 Technical data
Dimensions, weight:
Length:
Weight:
Grinding belt length:
Head can be swivelled by 60°
Motor:
Voltage:
Band speed:
Noise generation:
LWA: 103 dB(A)
General measuring
uncertainty:
Grip vibration:
- 12 -
approx. 330 mm
approx. 650 g
330 x 10 mm
10.8 V
200 to 700 m/min
LPA: 90 dB(A)
K=3dB
≤ 2.5 m/sec
2
Noise/vibration information
The information on vibration and noise emis-
sion has been determined in compliance with
the prescribed standardised and normative
measuring methods and can be used to com-
pare electrical devices and tools with each
other.
These values also allow a preliminary evalua-
tion of the loads caused by vibration and noise
emissions.
Warning!
Depending on the operating conditions, the
emissions that actually occur may deviate
from the values given above!
This applies in particular depending on the
workpiece to be machined and the insert tool
(especially its wear condition). Unsuitable
workpieces or materials, poorly maintained
tools, too high a feed rate or unsuitable insert
tools can signifi cantly increase the vibration
load and noise generation.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched
off, or is running but is not actually in use. This
can clearly reduce the vibration and noise load
across the entire work period.
Warning!
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable
bits and cutters!
• Take breaks if necessary when working with
the device!
lease note that the sound and vibration measu-
rements in particular have been performed with
Proxxon bits and cutters. When using third-
party brands we cannot guarantee compliance
with the statements given here!