Idiomas disponibles
Idiomas disponibles
6
Toilet Operation
Caution
Do not operate toilet without water supply turned on . Damage to internal components
may occur .
Freshwater Flush
6.1
6.1.1
Toilet system start-up
1 . Turn on fresh water supply to toilet .
2 . Press "Flush" switch (1) and hold for at least 10 seconds .
3 . Toss several sheets of toilet paper into bowl and repeat cycle .
The bowl should completely clear .
6.1.2
Normal flushing
FLUSHING TOILET
Press "Flush" switch (1) down and hold until waste drains from toilet bowl (about 10 – 20 seconds) .
This switch activates a macerator pump that siphons water and waste from the bowl, macerates,
and propels the effluent to the discharge line/holding tank .
To use less water for liquid-only flushes, press "Flush" switch for shorter period of time .
Freshwater Flush
6.2
6.2.1
Toilet system start-up
1 . Turn on fresh water supply to toilet .
2 . Press "Flush" switch (2) and hold for at least 10 seconds .
3 . Toss several sheets of toilet paper into bowl and repeat
cycle . The bowl should completely clear .
6.2.2
Normal toilet operation
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (1) and hold until desired water level
is achieved . (Do not press "Add Water" switch too long or
overflow may occur .)
FLUSHING TOILET
Press "Flush" switch (2) down and hold until waste drains from
toilet bowl (about 10 – 20 seconds) . This switch activates a macerator pump that siphons water and
waste from the bowl, macerates, and propels the effluent to the discharge line/holding tank . To use
less water for liquid-only flushes, press "Flush" switch for shorter period of time .
"DRY BOWL" OPERATION
During periods of rough travel, water in a toilet bowl can splash out and into the bathroom area . To
avoid this situation, press "Dry Bowl" switch (3) to drain water completely from toilet bowl . Water is not
added to bowl during or after pressing the "Dry Bowl" switch .
(with DFS-1F switch)
(toilet with DFST switch)
Dometic MasterFlush
1
2
1
3
7
