Idiomas disponibles
Idiomas disponibles
EN
9.3.1 DISPLAY
The remote control display shows information on the appliance's op-
erating status.
The display can be switched on by pressing the
The figure below shows the display during normal operating condi-
tions.
23.0° C
PELLET OFF
1
WOOD OFF
11:23
2
1 Operating status
2 Current time
3 Room temperature
4 Power set in "SET OUTPUT"
By pressing the
button it is possible to access the MENU and the
s
and
buttons can be used to select the desired item.
+
-
Pressing the
button allows for accessing the selected menu,
s
saving the changes made previously, while the
user back to the previous menu level, memorising also in this case the
changed made previously.
01-STAND-BY
02-CHRONO
03-SET CLOCK
04-LANGUAGE
05-SETTINGS
l
The remote control is equipped with an integrated
room temperature sensor, therefore the room tem-
perature shown on the display is measured by the
remote control itself:
The remote control should thus be positioned in an
■
optimal point of the room where the appliance is in-
stalled.
22
button.
O
3
3
4
Fig. 19
button takes the
E
MENU
Fig. 20
9.3.2 MENU
STAND-BY
If ENABLED
, once the temperature set in "SET ROOM" is reached,
v
the appliance enters the modulation mode and/or switches off. Dur-
ing the modulation phase, the wording "OK ST-BY" will appear on the
display, while when the appliance shuts down, "STAND-BY" appears.
If DISABLED
, once the temperature set in "SET ROOM" is reached,
o
the appliance enters the modulation mode and the switch-off is ex-
cluded. During the modulation phase, "MODULATION" will appear on
the display.
The figure below shows the display with the STAND-BY function EN-
ABLED.
STAND-BY
CHRONO
The CHRONO menu allows for accessing the various time schedules
for the switching on and off of the appliance (daily, weekly and week-
end).
In order to prevent any undesired switching on/off operations, only
activate and use a single programme at a time (daily, weekly or week-
end programme).
ENABL. CHRONO sub-menu
The ENABL. CHRONO sub-menu allows for enabling and disabling all
the CHRONO functions. For it to work properly, it should be enabled
with the
or
button only when at least one on/off programme
+
-
(daily, weekly or weekend) is enabled.
The figure below shows the display with the GENERAL CHRONO pro-
gramme enabled.
ENABL. CHRONO
COMMISSIONING AND USE
Fig. 21
Fig. 22
CS.DLA.IST_EN_Rev. 1.0_11-23
