Idiomas disponibles
Idiomas disponibles
E8/E9
Failure of IGBT sensor
E0
IGBT Overheat
EE
Display PCB failaure.
The above are the judgment and inspection of common failures.
ATTENTION! To avoid danger, please do not disassemble the unit by yourself!
9.
Installation
9.1
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5cm space shall be preserved
around the hole. Be sure the thickness of the work surface is at least 30mm. Please
select heat-resistant and insulated work surface material (Wood and similar fibrous or
hygroscopic material shall not be used as work surface material unless impregnated) to
avoid the electrical shock and larger deformation caused by the heat radiation from the
hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of
the worktop should be at least 3mm.
CCIG3BL723FLEX
CCIG9334C
CIG10033W
Under any circumstances, make sure the hob is well ventilated and the air inlet and
outlet are not blocked. Ensure the hob is in good work state. As shown below:
Note: The safety distance between the hotplate and the cupboard above the hotplate
should be at least 760 mm.
L(mm)
W(mm) H(mm)
590
520
590
520
Please contact service center to repair.
Check if the fan is still working. If not please
contact service center to repair.
Please contact service center.
D(mm)
62
58
62
58
17
A(mm)
B(mm)
560
490
560
490
X(mm)
50 min.
50 min.
