Technical Data; Health Hazard By Dust; Intended Use - Festool T18+3 Manual De Instrucciones

b) Always start drilling at low speed and
–
with the bit tip in contact with the work­
piece. At higher speeds, the bit is likely to
bend if allowed to rotate freely without con­
tacting the workpiece, resulting in personal
injury.
c) Apply pressure only in direct line with
–
the bit and do not apply excessive pres­
sure. Bits can bend causing breakage or
loss of control, resulting in personal injury.
3.3 Further safety instructions
– Use appropriate detection devices to look
for any hidden supply lines or consult your
local utility company. If the insertion tool
makes contact with live cables, it can result
in fire and electric shock. Damage to a gas
pipe can lead to an explosion. Penetration
of a water pipe can result in damage to
property.
–
Wear suitable personal protective equip­
ment: Ear protection and safety goggles.
CAUTION! Power tool can jam and cause
sudden kickback! Switch off immediately!
– Hold the power tool firmly in your hand.
Make sure the speed is adjusted correctly
when screwdriving. Be prepared for a high
reaction torque, which may cause the pow­
er tool to turn and possibly lead to injury.
Do not use the power tool in the rain or in
–
damp surroundings. Moisture in the power
tool may cause a short circuit and fire.
– Do not lock the on/off switch in place per­
manently.
Do not use power supply units or third-
–
party battery packs to operate cordless
power tools. Do not use third-party charg­
ers to charge the battery packs. The use of
accessories not expressly authorised by the
manufacturer can result in electric shocks
and/or serious accidents.
5

Technical data

Cordless drill
Motor voltage
No-load speed*
Max. torque
3.4

Health hazard by dust

WARNING! various dust created by pow­
er sanding, sawing, grinding, drilling and
other construction activities contains chemicals
known (to the State of California) to cause can­
cer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from chemically
treated lumber.
The risk from these exposures varies, depend­
ing on how often you do this type of work. To re­
duce your exposure to these chemicals: work in
a well ventilated area, and work with approved
safety equipment, such as dust masks that are
specially designed to filter out microscopic par­
ticles. Wash hands after handling.
WARNING
TO REDUCE THE RISK OF INJURY, USER
MUST READ INSTRUCTION MANUAL.
4

Intended use

Cordless drill suitable
– for drilling in metal, wood, plastics and
similar materials,
– for screwing in and tightening screws.
– intended for use with BP Festool battery
packs of the same voltage class.
The user is liable for damage and acci­
dents caused by improper and non-in­
tended use; this also includes damage and
wear caused by continuous industrial operation.
Soft material (wood)
Hard material (metal)
English
T18+3
1st gear
0 - 450 min
2nd gear
0 - 1500 min
35 Nm
50 Nm
18 V
-1
-1
9