Idiomas disponibles
Idiomas disponibles
DOORS AND LEVELING
Possible
Causes and/or R ecommended
Solutions
Refrigerator
unsteady or
it
•
Refrigerator
brake feet are not snug against the floor
- Remove the base grille. Turn both brake feet
rolls forward
when opening
(one on each side) clockwise,
the same amount,
until they are snug against
the floor. See
and closing doors or drawers
"Refrigerator
Leveling,
Door Closing
and Alignment."
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
iCE AND WATER
Ice maker
is not
producing
ice t
not producing
enough icet
or producing
small/hollow
ice
Possible Causes and/or
Recommended
Solutions
•
Refrigerator
is not connected
to a water supply_ or the water supply shutoff valve is not fully
turned on - Connect
the refrigerator
to a water supply and make sure the water shutoff valve is fully open.
•
Kink in the water source line - A kink in the water
line can reduce water flow,
resulting in decreased
ice
production,
small ice cubes, and/or
hollow or irregularly-shaped
ice. Straighten
the water line.
•
Ice maker is not turned on - Turn on the ice maker. See "Ice Maker
and Storage
Bin."
•
New installation - After connecting
the refrigerator
to a water
source, flush the water system. (See "Water
and Ice Dispensers.")
Wait
24 hours for ice production
to begin. Wait
72 hours for full ice production.
Discard
the first three batches
of ice produced.
•
Refrigerator
door
is not closed completely
- Close the door firmly.
If it does not close completely,
see "The
doors will not close completely."
•
A water
filter
is installed
on the refrigerator
- Remove the water
filter and operate
the ice maker.
If ice
volume
improves,
then the filter
may be clogged
or incorrectly
installed.
Replace filter
or install it correctly.
•
Large amount of ice was recently removed - Allow
sufficient
time for the ice maker
to produce
more ice.
•
Ice is jammed
in the ice maker
ejector arm - Remove ice from the ejector
arm using a plastic
utensil.
•
Inadequate
water
pressure - Verify
that the household
has adequate
water
pressure.
See "Water
Supply
Requirements."
•
Water
filter is installed
incorrectly
- Make
sure the filter
is properly
installed.
See "Water
Filtration
System."
•
A reverse osmosis water
filtration
system is connected
to your cold water
supply - This can decrease
water
pressure. See "Water
Supply
Requirements."
NOTE:
If questions
remain
regarding
water
pressure, contact
a licensed,
qualified
plumber.
23
