Idiomas disponibles
Idiomas disponibles
Recommended
Setting
" 3 Snowflakes"
Adjusting the Controls
If you need to adjust the temperature
in either the refrigerator
or
freezer
compartment,
use the settings
listed in the following
chart
as a guide.
•
Press the TEMP button
to display
the desired
number
of
snowflakes
from (1 snowflake
[least cold] to all snowflakes
[coldest]).
NOTE:
Except when starting
the refrigerator,
do not adjust the
control
more than one setting
at a time. Wait
24 hours between
adjustments
for the temperature
to stabilize.
CONDITION/REASON:
ADJUSTMENT:
REFRIGERATOR
too warm
FRIDGE TEMP one more
snowflake
FREEZER too warm/too
little ice
FREEZER TEMP one more
snowflake
REFRIGERATOR
too cold
FRIDGE TEMP one less
snowflake
FREEZER too cold
FREEZER one less
snowflake
Cooling On/Off
Your refrigerator
and freezer
will not cool when cooling
is
turned off.
To turn cooling
off, press and hold both the FAST COOL
and
MOISTURE
CONTROL
buttons, at the same time, for 3 seconds.
When
cooling
is off, the Cooling
Off icon will appear
on the
display.
To turn cooling
back on, press and hold both the FAST COOL
and MOISTURE
CONTROL
buttons,
at the same time, for
3 seconds. When
cooling
is on, the Cooling
Off
icon will
disappear
and the previously
selected
settings will be
displayed.
Additional
Features
Door Open Alarm
•
The Door Open
icon lights up whenever
either door is opened.
When
either
door is open for 5 minutes and cooling
is on, an
alert tone will sound three times, and the Door Open
icon will
flash seven times. This pattern
will repeat every 2 minutes
until
all the doors are closed properly.
The feature
then resets and
will reactivate
when either
door is left open again
for
5 minutes.
NOTES:
To mute the audible
alarm
while keeping
the doors open, such
as while cleaning
the inside of the refrigerator,
press any button
on the control
panel.
The alarm
sound will be temporarily
turned off, but the Door Open icon will still be displayed
on the
dispenser
control
panel.
•
Both doors must be fully closed
to turn off the Door Open
icon.
Fast Cool
The Fast Cool feature
assists during
times of high refrigerator
use,
full grocery
loads or temporarily
warm
room temperatures.
•
Press FAST COOL
to set the freezer
and refrigerator
to the
coldest
temperature
settings.
Press FAST COOL
again
to return
to the selected
temperature
set point.
NOTES:
The Fast Cool icon will be illuminated
while the refrigerator
is in Fast Cool mode.
The Fast Cool feature
will turn off automatically
after
24 hours.
Moisture Control
The moisture control
feature
turns on a heater to help reduce
moisture
on the door hinge seal. Use in humid environments
or when
you notice moisture on the door
hinge seal. The refrigerator
uses
more energy
when Moisture
Control
is on.
•
To turn on the Moisture
Control
feature,
press and hold
MOISTURE
CONTROL
for 3 seconds.
To turn off the Moisture
Control
feature,
press and hold
MOISTURE
CONTROL
for 3 seconds.
Air Filter Status Light and Reset
The filter
reset control
allows
you to restart the air filter
status
tracking
feature
each time you replace
the air filter. See "Install
Air
Filter."
•
Press and hold AIR FILTER for 3 seconds, to reset the air filter
status to Good.
The air filter
icon will turn blue.
15
